1. Preparation before work: Wear a hood, raindrops, glue gloves, safety helmets, glue gloves must be allowed to simply water, sore water, and allow them to be allowed to work; Add 109 sodium hydroxide solution water solution; turn on the anode rod back cover, use both hands to gently display the graphite anode board from the anode rod, and migrate to the graphite cleaning slot soak for 30 minutes.

2. Actual operation: Remove the graphite anode plate that soaks soaked for thirty minutes from the soaking solution, flatten the electroplating equipment on the wooden frame, and use 240#-320#water matte paper to clean the surface layer of the graphite anode plate. , Hold the positive film with one hand, gently press the policing paper with the other hand, and drink water to clean it until the stains are eliminated, and then use the water matte paper to remove the anode oxidation and touch the guidance. After that, clean all the liquid cold water, and check whether there is dirt on the surface layer. If so, clean up to tidy; eventually clean up the tank, clean it with drinking water, put it in pure water, soak the clean graphite with pure water blisters, soak the clean graphite with pure water blisters. The anode board is hung on the anode rod after the production is manufactured, and the anode stick is covered with the back cover.

3. Frequent problems: All operating processes should be carefully placed and lightly to avoid the rupture of graphite anode plates; when obtaining or installation of graphite anode plates, be sure to enter and exit vertically, do not touch the anode board; Manufacture to ensure safety.